944 Strut Brace Install

Step 1

1) Remove the nuts holding strut assembly to the body

2) Place bracket over studs with bracket upright toward the car

Step 2

3) Replace washers and nuts. Tighten to 18 ft-lbs using an X pattern
4) Repeat for the other side of the car
5) The rod ends are right and left-had thread. Included are matching jam nuts.
6) Install the jam nuts on the rod ends

Step 3

3) Replace washers and nuts. Tighten to 18 ft-lbs using an X pattern
4) Repeat for the other side of the car
5) The rod ends are right and left-had thread. Included are matching jam nuts.
6) Install the jam nuts on the rod ends

Step 4

8) Repeat for driver's side. For turbo's the bar will slightly press in on the master cylinder heat shield. This is normal.

Step 5

9) Turn bar toward front of car to take up "slack", tighten backing nuts and you're done!

*****Disclaimer*****
Shut the hood GENTLY to test clearances! DO NOT DROP OR SLAM THE HOOD! All cars are different, and the strut brace may fit differently on your car. This is not a problem with 99.9% of the cars but KLA Industries WILL NOT be responsible for ANY damage. If you do have a fitment problem, please email or call so we can help determine where the problem is and help you solve it. If we can't get things just right to your satisfaction, we will let you return the strut brace for a refund.