964/993 Strut Brace Install

1. Remove 3 nuts holding strut assembly to the body, two nuts toward the front of the car, one rear/inner nut
2) Place bracket over studs with long leg of bracket over front two studs as in the picture

3) Replace washers and nuts.  Tighten to 18 ft-lbs. 
4) Repeat for other side of car.

​5) Screw rod ends into bar.   The end of the bar with the knurl is a left hand thread.
6) Install bar on  brackets and tighten.  Hardware order is-bolt/bar/bracket/nut.  Length can be adjusted by the ends.
7) Turn bar to take up "slack".  Tighten backing nuts.
8) You're done!