944/951 Tow Block Install 

Step 1

Remove bumper from car.  This is done by removing bolt from access hole on under side of bumper.

Step 2

Disconnect parking light wiring harness.

Step 3

Find a suitable spot to mount tow block.  Center punch holes for drilling.

Step 4

From the inside of the bumper, drill small holes where you center punched.

Step 5

Turn bumper over and drill out the mounting holes the rest of the way.
Small mounting holes are 11/32".  Large center hole is 3/4".

Step 6

Drilling out large center hole.

Step 7

Mount block on inside of bumper using supplied hardware

Step 8

Inside view of completed install.

Step 9

Front view with tow eye installed.

towinstall-1.jpg
towinstall-2.jpg
towinstall-3.jpg
towinstall-4.jpg
towinstall-5.jpg
towinstall-6.jpg
towinstall-7.jpg
towinstall-8.jpg
towinstall-9.jpg