TOW BLOCK INSTALL

Remove bumper from car.  This is done by removing bolt from access hole on under side of bumper.

Disconnect parking light wiring harness.

Find a suitable spot to mount tow block.  Center punch holes for drilling.

From the inside of the bumper, drill small holes where you center punched.

Turn bumper over and drill out the mounting holes the rest of the way.
Small mounting holes are 11/32".  Large center hole is 3/4".

Drilling out large center hole.

Mount block on inside of bumper using supplied hardware.

Inside view of completed install.

Front view with tow eye installed.