964/993 STRUT BRACE INSTALL
|
1) Remove 3 nuts holding strut assembly to the body. 2 nuts toward front of car. 1 rear/inner nut. |
|
2) Place bracket over studs with long leg of bracket over front 2 studs as in the picture |
| 3) Replace washers and nuts. Tighten to 18 ft-lbs. |
| 4) Repeat for other side of car. |
| 5) Install bar on brackets and tighten. Hardware order is-bolt/bar/bracket/nut. Length can be adjusted by the ends. |
| 6) Turn bar to take up "slack". Tighten backing nuts. |
| 7) You're done! |